This website stores cookies on your computer. These cookies are used to improve your website experience and
provide
more personalized services to you, both on this website and through other media. To find out more about the
cookies
we
use, see our Privacy Policy.
We won't track your information when you visit our site. But in order to comply with your preferences, we'll have
to
use just one tiny cookie so that you're not asked to make this choice again.
How should I install bipotentiostat & multichannel potentiostat?
Source：Corrtest
Time：2021-12-02
View：696
Installation of Bipotentiostat and multichannel potentiostat
(FOR MODEL CS2350M / CS2150M /CS310X)
The installation process is the same for bipotentiostat and multichannel potentiostat
1. Software installation
(1) Use the Ethernet cable to connect the computer with the instrument. Power on the instrument.
(2) Open the “software installation” folder, right click the “ CS Studio setup.exe”, and run as administrator.
(3) For potentiostat more than one channel, we use Ethernet communication. So there is no need to install drivers. Firstly, install the .net 3.5. If your computer has already installed it, there will be a prompt as follows.
If it has not installed in your computer, just follow the steps to finish installation of .net 3.5.
(4) Click install CS Studio5. Created a shortcut is on the desktop.
2. IP address configuration (Windows 10 operation system as an example)
Connecting the instrument(Bipotentiostat or multichannel potentiostat) with computer by Ethernet cable, you should reset the IP address of the computer.
(1) Find the “Network and sharing centre”
Then, Ethernet →Network and sharing center
(Or
→ Network and sharing center)
(2) Click “Ethernet” shown as below:
.png)
(3) Click “Properties”, then check “Internet Protocol version 4(TCP/IPv4)”
(4) Fill in the IP address exactly as below:
(5) Open CS Studio5 software, “Setup” → Connection→ “Ethernet” →Manual
(6) When the bipotentiostat CS2350M is successfully connected with the computer, there will be model and serial number shown on the software interface.
(FOR MODEL CS2350M / CS2150M /CS310X)
The installation process is the same for bipotentiostat and multichannel potentiostat
1. Software installation
(1) Use the Ethernet cable to connect the computer with the instrument. Power on the instrument.
(2) Open the “software installation” folder, right click the “ CS Studio setup.exe”, and run as administrator.
(3) For potentiostat more than one channel, we use Ethernet communication. So there is no need to install drivers. Firstly, install the .net 3.5. If your computer has already installed it, there will be a prompt as follows.
(4) Click install CS Studio5. Created a shortcut is on the desktop.
2. IP address configuration (Windows 10 operation system as an example)
Connecting the instrument(Bipotentiostat or multichannel potentiostat) with computer by Ethernet cable, you should reset the IP address of the computer.
(1) Find the “Network and sharing centre”
Then, Ethernet →Network and sharing center
(Or
→ Network and sharing center)(2) Click “Ethernet” shown as below:
(3) Click “Properties”, then check “Internet Protocol version 4(TCP/IPv4)”
(4) Fill in the IP address exactly as below:
(5) Open CS Studio5 software, “Setup” → Connection→ “Ethernet” →Manual
(6) When the bipotentiostat CS2350M is successfully connected with the computer, there will be model and serial number shown on the software interface.
Home About Us Potentiostat/Galvanostat Accessories Support Contact Us
Copyright By © 2008-2021 Wuhan Corrtest Instrument Corp., Ltd
Contact Us
+86 13469965984
Decline
Accept